Price: $585.00
SKU: ELE54450A
Brand: e Marine
    Mounting:

    Update price
    Quantity:

    e10 Control Panel 48 Volt 70 Amp
    Wind Turbine Control Panel

    If you need to control both wind and solar see our e20 PANEL models.

    The e10 Wind Turbine Control Panel  It is pre-engineered to make wiring the wind turbine easy - just attach two wires from your battery  and two wires from the turbine to the large clearly labeled terminals. It could not be simpler. The flush mount panel includes a pre-wired "Stop / Run Switch" with noise suppressors, Digital Ammeter (displays Current)  and Circuit Breaker. The panel comes complete with instructions and is pre-calibrated and ready to use.

    Recommended for use with the Zephyr Airdolphin Pro or any other wind turbines that has a built-in regulator and a output current of 70 amps or less for a 48 V nominal DC system. Turbines with out built-in regulators can also be used provided a diversion load controller is installed on the battery bank. Control panel includes Instructions and mounting template.

     

    e10 Enclosed Version – the e10 panel is available in a self-contained enclosure. The enclosure is non-corrosive, water resistant and comes with the e10 panel mounted and sealed. Three watertight non-corrosive cable connectors are also included. Requires four mounting screws to secure in place (not included). Feed through holes for wire cable clamps must be drilled (13/16”) into the enclosure leaving complete versatility to the installer for wire entry location.

    Mechanical Specifications:

    Panel Mount Outside Dimensions: 7.44"L x 6.25" H x 3.5"D (Mounts using six #10 screws.)

    Panel Mount Cutout Hole: 6.1" L x 4.75" H

    Enclosure Dimensions: 7"W x 9"L x 5"D

    More detailed information:
    PDF e10 / e20 Cutout Template