e Marine

Run/Stop Switch with Face Plate, 15' 14-3 wire and interconnect terminal block for use with 3 phase wild AC wind generator 400W or less. It allows remote wind generator Stop/ Run switch to be located in an easy to access area.

e10 Control PanelWind Turbine Control Panel If you need to control both wind and solar see our e20 PANEL models. The e10 Wind Turbine Control Panel  It is pre-engineered to make wiring the wind turbine easy - just attach two wires from your battery  and two wires from the turbine to the large clearly labeled terminals. It could not be simpler. The flush mount panel includes a pre-wired "Stop / Run Switch" with noise suppressors, Digital Ammeter (displays Current) and Circuit Breaker....

Canvas Tee Top Kit 200W is designed for installation on center console boat that have a soft Bimini Top. The Canvas Teetop kit is predesigned and set up for self installation, are all-inclusive there-by eliminating equipment guesswork and/or missing parts during installation. The end result is a kit that will install quickly and work once installed. There is nothing to turn on or off, everything is automatic and the batteries will be charged up and topped off ready for a full fun packed day of...

Copper Rod 18" with Adjustable Base

25 Amp ATC Fuse

Used in Automotive and low-voltage control circuits to 32V, Operating Temperature Range -40°C to 100°C, 95% RH non-condensing. Case color indicates amperage rating.  Never replace  a fuse amperage  rating greater than the amperage size being replaced or it may cause physical or personal harm.Ratings:    P/N (amp)     Color codeATC-1           BlackATC-2       &n...

e20 SOLAR PV and WIND Turbine Hybrid Control Panel provides a single on-board operator station to control and monitor Solar PV and Wind Turbine renewable energy systems. It will support Wind Turbines to 250W and Solar PV panels to 300W (36 cell)/ 250W (60cell) managing upwards of 190 amp-hrs of daily energy production. Designed to work on a nominal 12 Volt system (24V is also available) and can be ordered as a flush mounted Panel or in a water resistant enclosure.The e20 is equipped with two...

Box of 5, 20A  Barrel 1 x 1-1/4\"

CLASS “T” FUSES Offer extremely fast short circuit response making an ideal circuit protector for high amperage electronic components such as inverters. Extremely current-limiting design minimizes the damaging heating and magnetic effects caused by short-circuit currents.   FEATURES • 20,000 Ampere interrupt capacity • 160V DC Maximum • UL Rated for DC applications under UL 198L ...

Ground Rod Clamp 1/2" or 5/8"

SOLAR PV and WIND Turbine Hybrid Control Panele20 Control Panel provides a single on-board operator station to control and monitor Solar PV and Wind Turbine renewable energy systems. It will support Wind Turbines to 400W and Solar PV panels to 300W (36 cell)/ 250W (60cell) managing upwards of 190 amp-hrs of daily energy production. Designed to work on a nominal 12 Volt system (24V is also available) and can be ordered as a flush mounted Panel or in a water resistant enclosure.The e20 is...

Maxi Fuse 50AMP/ 32 VDC

1.5" long Copper Nail

Hybrid kits are the best solution for renewable energy on board your vessel.  The combination of solar PV power during the daytime combined with 24 hour wind capability optimizes energy production in most weather conditions. The air X wind turbine is equipped with high performance carbon fiber blades which allows it to operate whisper quiet with improved performance in low winds.  Kits are all-inclusive allowing easy installation. Hybrid Wind/Solar Kit includes: 2 Solarland 85W Solar...

Maxi Fuse 60AMP/ 32 VDC

Copper Conductor Clamp

Fiberglass Teetop Solar Charging Kit Includes Solarland 160 Watt Panel is designed to work with a nominal 12 Volt battery system with either flooded or AGM type batteries. Fiberglass Teetop Solar Charging Kit 160W is available in two versions:--> Fiberglass Teetop Kit: Kit includes the 160W solar panel (with easy connect water resistant terminal box), four "Z" mounting brackets with hardware, 30' of 12-2 Marine grade wire, 6' of 10-2 Marine grade wire, 6 amp Charge Controller (regulates...

Hybrid kits are the best solution for renewable energy on board your vessel. The combination of solar PV power during the daytime combined with 24 hour wind capability optimizes energy production in most weather conditions. The Rutland 1200 Wind Turbine is equipped with a powerful but quiet operation of the new Tri-namic Blade that brings together low wind speed start up with high wind speed power performance and almost silent running across all wind speeds. Kits are all-inclusive allowing...

30 Amp ATC Fuse

Stop/Run  Switch - (50 ADC) DC rated & Sealed

Copper Ground Rod 10' x 5/8"2 x 5' with coupler

Box of 5, Barrel 1 x 1-1/4"10 Amp, 20 Amp, or 30 Amp.

35 Amp ATC Fuse

Maxi Fuse 30AMP/ 32 VDC