Victron LiFePO4 Battery Accessories

The Battery Alarm is a small and low cost alarm panel which monitors your battery bank. It features both audible and visual alarms, as well as a potential free contact with normally open and normally closed contacts. Alarm thresholds and hysteresis are programmable by DIP switches. See manual for more information.Instruction installMore Info ...

VE.Bus to BMS 12-200 alternator control cableDATA SHEET

The Battery Switch ON/OFF 275A is suitable for battery systems up to 48V. It has a unique ergonomic and aesthetic knob design. The knob is removable for isolation or safety purposes. The Battery Switch can be either surface or panel mounted, providing flexibility during install. The Battery Switch meets the ISO8846 Ignition Protection standard and is suitable for use in an engine room.DATA SHEET ...

The VE.Bus BMS protects each individual cell of a Victron lithium-iron-phosphate (LiFePO4 or LFP) battery. Each individual cell of a LiFePO4 battery must be protected against over voltage, under voltage and over temperature. Victron LiFePO4 batteries have integrated Balancing, Temperature and Voltage control (acronym: BTV) and connect to the VE.Bus BMS with two M8 circular connector cord sets.The BTVs of several batteries can be daisy chained. Please see our LiFePO4 battery documentation for...

The mini BMS can replace the VE.Bus BMS in several applications. It is however not suitable for use with VE.Bus MultiPlus and Quattro inverter/chargers: it has no VE.Bus interface. The miniBMS is intended for use with Victron Smart LiFePo4 batteries with M8 circular connectors.The miniBMS has two outputs, similar to the VE.Bus BMS. Part Number: BMS400100000 miniBMS information: Victron miniBMS Manual ...

The Inverting remote on-off cable is intended for products which require active pull down of the remote control terminal to switch on, while the source signal turns high when switch on is required.The Inverting remote on-off cable connect the (discontinued) Phoenix Inverter 12/180, 24/180, 12/350 or 24/350 to a VE.Bus BMS or a BlueSolar MPPT Charger that features a load output: • VE.Bus BMS: the Inverter will be switched off when the batteries are empty• BlueSolar...

The Non inverting remote on-off cable translates the remote on/off driver logic from the VE.Bus BMS (normally high, and open circuit in case of alarm) to the logic needed by above products: active pull down to switch of. The Non inverting remote on-off cable connect the following products to the VE.Bus BMS:- Skylla-TG all models- Battery Protect models BP40i, BP60i and BP200i (all discontinued). Part Number: ASS030550200 Non inverting remote on-off cable information: Non inverting...

Victron M8 circular connector Male/Female 3 pole cablesPart Numbers:1 Meter: ASS0305601002 Meter: ASS0305602003 Meter: ASS0305603005 Meter: ASS030560500

Smart Battery Management System 12/200 protects the alternator (and wiring), and supplies up to 200A in any DC load (including inverters and inverter/chargers. Part Number: BMS012201000 BMS 12/200 information: Smart BMS 12/200 Manual Smart BMS 12/200 Datasheet ...