CruzPro

CruzPro TMT 1 Plastic Transom Water Temp with 30' cable is designed to provide the highest performance for your boat in a high speed, high performance transom-mounted unit. The CruzPro TMT-1 can be use with WTP-35/WTP-65 or T35/T65 or MaxVu110 Model# TMT-1 CruzPro VAF110 Digital Monitor Specifications: Operating Voltage:  9.5 - 33.0 VDC  Current Drain:  0.035 amps nominal Data:  Volts, Amps, Frequency, Killowatts (kW) Data Output:  NMEA 0183 serial data...

CruzPro D110 Digital DSP Depth Sounder compact to 1000 Ft/ 300 meters with shallow and deep Alarms, anchor drag alarm, keel offset with NMEA 0183 output.  The D110 1000' DSP Depth Sounder uses Digital Signal Processing (DSP) to reliably display water depth from 1.2 foot (0.4 Metre) to 1000+ feet (365 Meters). Depth can be displayed in feet, meters or fathoms. Variable display damping is provided so the user can optimize response speed against display stability...

CruzPro OP60 Oil Pressure Gauge unique, low and high pressure alarms. NMEA 0183 Data Output.Preprogrammed for popular senders from VDO, Teleflex, Faria, etc. The OP-60 Oil Pressure Gauge displays engine oil pressure in Psi or Bars. Model#: OP-60R Round OP-60S Square OP60 Digital Oil Pressure Gauge Specifications: Supply Voltage:  9.5 - 33.0 VDC  Current Drain:  0.018 amps nominal Display:  4 digit LCD, 5 levels of backlighting Data:  Oil Pressure, 0 to 75, 0 to...

CruzPro T65 Digital Temperature Display continuously monitors three separate sensors and displays temperature from -20 deg F (-29 deg C) to +140 deg F. (+60 deg C). The T-65 comes factory calibrated but can be user calibrated in the field for each individual sensor for spot-on accuracy. All set-up and calibration constants are saved to non-volatile memory. The T65 uses standard 10K NTC thermister temperature sensors (the type most often used in speed/temperature and depth/temperature...

CruzPro GD55 Gas Vapor Monitor uses new technology to lower the power requirements for the sensor and draws only 0.12 amps at 12VDC. The GD-55 gas detector comes with one LPG/Petrol/Gasoline sensor with 5 meters (16 feet) of cable. Installation into a round 2.4" diameter (55mm) hole requires only a screwdriver. An instruction manual and all mounting hardware is provided Model# GD-55R Round GD-55S Square GD55 Marine Gas Detector Specifications: Operating Voltage:  10.5 - 16.0...

CruzPro THT 1 Bronze Thru Hull Temperature Transducer with 30' cable - Marine temperature transducer with bronze thru-hull fitting with 30' cable for WTP-35/WTP-65, T35/T65 or MaxVu110. Model# THT-1 CruzPro VAF110 Digital Monitor Specifications: Operating Voltage:  9.5 - 33.0 VDC  Current Drain:  0.035 amps nominal Data:  Volts, Amps, Frequency, Killowatts (kW) Data Output:  NMEA 0183 serial data output at 4800 BAUD of: $IIXDR,I,aaaa,A...

CruzPro SLT60 Digital Speed Temperature Log provides speed and average speed up to 50.0 Knots (58 M.P.H.) in tenths, very accurate water temperature in degrees F or C in tenths, trip log to 999.9 miles, permanent log to 9,999 miles and elapsed time in Minutes/Seconds and Hours/Minutes. A race timer can be started with one of two pre-settable start times. Model# SLT-60R Round SLT-60S Square CruzPro SLT60 Specifications: Operating Voltage:  9.5 - 33.0 VDC  Current Drain: ...

CruzPro CH60 Intelligent Chain Counter Windlass Controller advises how much chain is out, displays windlass battery voltage, slows windlass, NMEA 0183 data output, etc. The CH-60 chain counter can be programmed to back-jog the chain a few links when you remove your finger from the UP button, removing tension off the chain, capstan and windlass gears increasing windlass life and automatically "parks" the chain into a chain stopper. Model# CH-60R Round CH-60S Square CruzPro CH60...

CruzPro WTP110 Precision Sea Water Temperature Gauge provides accurate sea water temperature to 0.01deg F/C. NMEA 0183 data output and Hi/Lo temperature alarms, trend indicator and Min/Max temp. memory. The WTP-110 Works with standard 10Kohm thermistor transducers (CruzPro THT-1 thru-hull or TMT-1 transom mount transducers below) or popular 30Kohm Dytek temperature senders. Model# WTP-110 WTP110 Sea Temp Gauge Specifications: Operating Voltage:  9.5 - 33.0 VDC ...

CruzPro SB2 Dual Sender Buffer allows a CruzPro gauge (FU30/FU60, TL25/TL55, OP30/OP60, etc.) and one existing analog gauge to share a single station 10-180 ohm or 240 -33 ohm sender.  The SB2 Dual Sender Buffer Makes adding a digital gauge to an existing analog set-up very easy. One SB-2 will buffer two separate senders (e.g. an oil pressure and water temperature sender, etc.). Model# SB-2 SB2 Dual Sender Buffer Specifications: Supply Voltage:  10.5 to 33.0...

CruzPro RP110 Remote Data Repeater can monitor up to four separate data channels and up to ten new sentences can be stored in the on-board flash memory; these can be re-programmed as many as 1 million times so your RP110 will never go obsolete. The Intelligent NMEA 0183 Remote Data Repeater is already factory pre-programmed to repeat 200 "standard" pre-defined NMEA 0183 sentences. Model# RP-110 CruzPro RP110 Specifications: Operating Voltage:  9.5 - 33.0 VDC  Current...

CruzPro EFS20 Automatic Dual Bilge Pump Controller 12V with Probe & Alarm 12 VDC. Dual pumps for redundancy while keeping track of number of activations. The EFS-20 12V can run two pumps drawing a total of up to 20 amps continuously, and larger pumps for shorter periods of time. The internal thermal shutdown protects the EFS-20/12 from overheating when driving large pumps. Model# EFS-20/12 CruzPro EFS-20/12 Specifications: Operating Voltage:  9.5 to 18 VDC, 0.02 ampere...

CruzPro VAF60 Digital AC Volts/Amps/Hz/kW Monitor provides accurate low cost digital instrumentation for AC volts, amps, frequency and kW. The VAF60 Monitor displays ac voltage from 90 to 300 VAC RMS, AC current from 0 to 150 amps, AC frequency from 40 to 70 Hz and computes volt-amps (kW) from 0.0 to 45.0 kW. The CruzPro VAF60 can be set to Low and High voltage alarms and Low and High frequency alarms. The VAF60 built-in 85 dB alarm is activated, it will sound and the display will flash. The...

CruzPro AM60 Digital Rudder Angle Indicator learns sender resistance, easy to calibrate, individual limit alarms for Port/Stbd. NMEA 0183 serial data output or External Alarm output. The AM-60 can be operated from a 9.5 to 33.0 VDC power supply. The AM60 will function with all standard rudder angle sensors and can be connected as either a master or slave Model# AM-60R Round AM-60S Square CruzPro AM60 Specifications: Operating Voltage:  9.5 - 33.0 VDC  Current...

CruzPro VAF110 4" Digital AC Volts / Amps / Frequency / kW Monitor provides accurate low cost digital instrumentation for AC volts, amps, frequency and kW. The VAF110 digital monitor displays ac voltage from 90 to 300 VAC RMS, AC current from 0 to 150 amps, AC frequency from 30 to 100 Hz and computes volt-amps (kW) from 0.0 to 45.0 kW. The CruzPro VAF110 can be set to Low and High voltage alarms, Low and High frequency alarms and a high kW alarm. The VAF110 built-in 85 dB alarm is...

DISCONTINUED ITEM..PLEASE SEE MTS10310CruzPro GD10 LPG Petrol Gas Vapor Detector, monitor and alarm detects gas vapors at 25% of the concentration required for an explosion (LEL or Lower Explosive Limit).The GD10 marine gas detector comes with one LPG/Petrol/Gasoline sensor built-in and uses switch-mode technology to lower the power requirements for the sensor and draws less than 0.10 amps at 12VDC.Base Model Gas Detector. 12VDC low current drain (0.12 amps). Self contained gas sensor. For LPG...

VTCT1 - Volt/Amps Xformer for VAF meter

Spare gas sensor assembled with 16-ft cable (5 meters) for use with GD-20B and GD-25 gas detector meters.Model#  GD-27 CruzPro GD-20B Information: CruzPro GD-20B Manual ...

CruzPro GD20B Gas Vapor Monitor detects gas vapors at 10%, 20% or 30% of the concentration required for an explosion (LEL or Lower Explosive Limit). The GD20 uses new technology to lower the power requirements for the sensor and the GD20 can be programmed to put itself to sleep for further power conservation. The GD-20 Gas Vapor Detector can be programmed to be active continuously or wake up every 5 minutes for a sniff. If the GD-20 senses a dangerous concentration of gas, it sounds the alarm,...

CruzPro CS60 Quad Clocked Switch can switch up to 4 amps per circuit (16 amps total) under control of an accurate digital clock. The CruzPro Round CS60 can be programmed to automatically switch each circuit ON and OFF up to 3 times per day per circuit or periodically switch each of the four circuits ON and OFF for different time periods. For example: You can program a circuit to turn ON at 7:00 PM and turn OFF at 2:00 AM or program one or more circuits to switch ON for 5 minutes every...

CruzPro THST 1 Plastic Speed Thru Hull Transducer with 30' cable - Marine speed/temperature transducer with 30' cable for SLT-30/SLT-60. Model# THST-1 CruzPro VAF110 Digital Monitor Specifications: Operating Voltage:  9.5 - 33.0 VDC  Current Drain:  0.035 amps nominal Data:  Volts, Amps, Frequency, Killowatts (kW) Data Output:  NMEA 0183 serial data output at 4800 BAUD of: $IIXDR,I,aaaa,A,VAF30,*CS - AC Amps $IIXDR,F,bb.b,H,VAF30,*CS - AC...

CruzPro EFS10 Automatic Bilge Pump Controller 12V with Probe & built in Alarms 12VDC, will keep track of how many times activated. The EFS-10 12V monitors the presence of water in the bilge of your boat and automatically turns on your pump if the electronic float switch detects water continuously for more than 15 seconds. Once turned on, the EFS10/12 pump will run for at least 15 seconds. The EFS10/12 Bilge Pump can also be manually activated from the front...

CruzPro VAH60 Digital Volts Amp Hour Monitor provides accurate low cost digital instrumentation for batteries between 9.5 and 33 Volts. The VAH-60 displays battery voltage and charging or discharge current and tells you how much battery capacity has been consumed and how much is remaining. It keeps track of all current entering and leaving the battery and applies the appropriate Peukert's and efficiency factors. You can set Low and High voltage alarms and Low Amp-Hours Remaining alarms....

CruzPro EFS20 Automatic Dual Bilge Pump Controller 24V with Probe & Alarm 24 VDC. Dual pumps for redundancy while tracking number of activations. The EFS-20 24V is powerful enough to drive some very large pumps but may overheat if required to do so for very long. If the EFS20/24 overheats, it will shut down and rapid flash the Pump 1 On/Off and/or Pump 2 On/Off LEDS to indicate the overheated condition. Model# EFS-20/24 CruzPro EFS-20/24 Specifications: Operating Voltage:  9.5 to...