Sailboat hydrogenerator buying guide
A hydrogenerator hangs a small propeller in the water behind the transom and turns boat speed into battery charge. Watt&Sea Cruising models pair a sealed permanent-magnet generator on an aluminum leg with a separate converter that regulates the charge. The choices are output, leg length and propeller.
300 W or 600 W
Both Cruising models use the same CV-03 converter, rated 600 W, which detects a 12 V or 24 V bank automatically and charges at up to 44 A (12 V) or 22 A (24 V). The difference is the generator: the Cruising 600 is rated 600 W nominal, the Cruising 300 is rated 300 W. Compare your daily consumption on passage with what each model can replace: the 600 is the choice for heavy loads such as an autopilot, refrigeration or a watermaker, the 300 for lighter ones. The converter also has a solar input (up to 50 V and 14 A), and it charges lithium batteries since its absorption voltage is capped at 14.3 V or 28.6 V.
Leg length and mounting
- Watt&Sea recommends about 12 in (300 mm) from the water surface down to the propeller axis. Deeper keeps the propeller out of the hull's wake but increases loads on the mount.
- The 38 in (970 mm) leg is Watt&Sea's recommended compromise for most monohulls and stays immersed when heeled.
- The 24 in (610 mm) leg is meant for very large monohulls with a unit on each side.
- Keep the unit offset from the rudder, propeller and saildrive. Disturbed flow is one of the most common causes of low output.
- The transom mounting must take about 300 kg (660 lb) of load. Lifting takes up to about 40 kg (88 lb) of pull, which is why a 4:1 or 6:1 hoist is used.
Choose the propeller for your speed
The standard 240 mm propeller works from 4 to 11 knots. The 280 mm covers 3 to 9 knots for slower or heavier boats, and the 200 mm covers 6 to 13 knots for fast boats. Watt&Sea estimates average drag at 6 knots at about 10 kg (22 lb).
| Model | Nominal power | Leg | Generator weight | Max charge current (12 V / 24 V) |
| Cruising 300 | 300 W | 38 in (970 mm) | 7.1 kg (15.7 lb) | 44 A / 22 A |
| Cruising 300 | 300 W | 24 in (610 mm) | 6.3 kg (13.9 lb) | 44 A / 22 A |
| Cruising 600 | 600 W | 38 in (970 mm) | 8.2 kg (18.1 lb) | 44 A / 22 A |
| Cruising 600 | 600 W | 24 in (610 mm) | 7.4 kg (16.3 lb) | 44 A / 22 A |
Max charge current is the converter rating. The CV-03 converter weighs 1.5 kg.
Products in this collection
Questions
How does a marine water generator work?
Water flow spins the propeller, which drives a permanent-magnet alternator producing three-phase AC. The converter turns that into regulated DC for the batteries, with absorption at 14.3 V and float at 13.8 V on a 12 V bank.
Which hydrogenerator size suits a sailboat?
For most monohulls, a Cruising model with the 38 in leg. Choose 300 W or 600 W by your daily consumption, and pick the propeller to match the speed you usually sail at.
Can a hydrogenerator run while motoring?
Watt&Sea advises lifting it. With the engine charging, the converter sees full batteries and lets the propeller freewheel, which can damage the generator. Lift it when reversing, too.
What maintenance does a sailboat hydro generator need?
Rinse it with fresh water, clean the shaft, and check the mounts and connections. Watt&Sea recommends a service every two years or 10,000 miles.
Need help choosing? Contact us with your boat's length, transom height and typical cruising speed, and we will help you pick the model, leg and propeller.